![]() ![]() If there are clearance issues, the new link may be bent slightly. That the new link does not bind against the turret frame or the turret pan. Secure the O-Ring pin with the #10 washer and O-Ring provided. #Download Brunswick Pinsetter Manual A2 install#Some turretįrames may require dropping the turret indexing bell crank down to get clearance to install the Of the turret indexing bell crank and put the indexing link back in its normal position. ![]() Use the new longer O-Ring pin with the new link on the outside (7 pin side) Link should be facing up to provide clearance from the frame. ![]() Install the new solenoid plunger and link assembly into the new solenoid. Solenoid Link and Plunger Assembly Installationġ. Make sure the bracket is level with the turret frame.įigure 2 shows location of the solenoid mounting plate after installation. Plate and tighten the set screws and jam nuts. Move to the top of the pinsetter and reach down to position the solenoid and mounting At that point the mounting plate is hanging loose from the turretįrame. Plate, with the clamp end toward the rear of the turret frame, until the plate can be lifted enoughīeyond the turret frame to allow the clamp end to hook over the rear of the turret frame. Install the mounting plate with the solenoid fastened to it from under the turret. INDEXING LINKAGE IS CRITICAL FOR MAXIMUM PERFORMANCE.Ĥ. IMPORTANT: THE ALIGNMENT OF THE SOLENOID AND LINK TO THE EXISTING Remove the rear x-washer pin from the turret-indexing link (connected to the turret indexing bell The 12-150187-000 turret pan from the turret frame.ģ. Location of solenoid mounting plate assembly 12-150340-000: (Refer to Figures 1 & 2). WARNING! DISCONNECT THE MAIN POWER CORD TO THE PINSETTER.Ģ. Make sure there are no pins in the turret, then cycle the pinsetter to 270 degrees Setting New Pins Allow 40 minutes for installation)īe sure the turret is indexing correctly, review #41 in the adjustments section of the service manual “Turret Index Trip Lever Adjustment”, and replace any worn indexing parts such as the 12-150235-000 latchĪssembly and 12-150289-000 short turret link.ġ. (Please read entire installation instructions before proceeding. Solenoid Mounting Plate 12-150340-000 Installation 12-150338-000 Reed switch & Mounting Bracket Assemblyġ ea. 12-862028-000 Electronic Five Pin Indexing Kit 1 ea. Of the “A”, “Jet Back” or “A-2” pinsetter.ġ ea. ![]() With a positive index electronic system that eliminates wear and reduces pinsetter stops in this critical area The purpose of this kit is to replace five pin indexing components that wear and can cause pinsetter stops ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |